产品搜索
联系方式
产品目录
产品资料
  首页 >>> 产品目录 >>> 汤浅电池

台湾汤浅NP40-12B电池

如果您对该产品感兴趣的话,可以
产品名称: 台湾汤浅NP40-12B电池
产品型号: NP40-12B
产品展商: 昱跃国际贸易(上海)有限公司

简单介绍
台湾汤浅NP40-12B电池 额定电压 / 容量:12V / 40AH(20 HR) 尺寸 :197± 1 mm 宽 :165± 1 mm 槽高:175± 1 mm 总高 :175± 2 mm 端子:螺丝式Bolt 重量约14.5 kg 电槽材质: NP40-12 ABS 难燃等级UL94HB NP40-12FR 难燃ABS 难燃等级UL94V0

台湾汤浅NP40-12B电池的详细介绍

台湾汤浅NP40-12B电池规格
 
 
   台湾汤浅NP40-12B电池 阀调式铅酸蓄电池 Valve Regulated Lead Acid(VRLA)RECHARGEABLE BATTERY
    1.型式 Model:NP40-12 / NP40-12FR
   
    2.额定电压 / 容量 Nominal Voltage / Capacity:12V / 40AH(20 HR)
   
    3.诸元 Mechanical Spec
   
    (1)尺寸 Measurements长 Length: 197± 1 mm
    宽 Width : 165± 1 mm
    槽高 Case height : 175± 1 mm
    总高 Overall height : 175± 2 mm
   
    (2)端子 Terminal :螺丝式Bolt
   
    (3)重量 Weight 约 About : 14.5 kg
   
    (4) 电槽材质Container material:
   
    NP40-12 ABS 难燃等级UL94HB ABS Flame class UL94HB
    NP40-12FR 难燃ABS 难燃等级UL94V0 Flame Retardant ABS Flame class UL94V0
   
    4.构造 Construction:蓄电池系由阳极板、阴极板、电槽、盖、隔离板、电解液等组成 ,并设有阳、阴极板引出端子。密闭构造机能为蓄电池产生之气体由阴极板吸收且不必补水。
    This battery is composed of positive plates, negative plates, separators, container, lid,
    electrolyte etc., and is equipped with positive and negative polarity terminals.
    Any emitted gas from the battery is minimized with the negative plate gas recombinant
    method, thus requiring no topping up of electrolyte.
   
    5.外观 External appearance:不得有漏液、污垢、裂痕、变形等现象。
    Battery shall be without acid leakage, conspicuous stain, scar or deformation.
   
 
电池性能
 
 
    性能测试温度: 25±2℃ ( 特别指定不在此限 ) Temperature of tested battery shall be 25±2℃, if not specified.
   
    放电容量 Discharge capacity:(此数值为最小值This value is the minimum)
    PERFORMANCE DATA AT 25 (77 )℃ ℉ - Amperes and Watts
    TIME F.V. 5M 10M 15M 20M 30M 45M 1H
    10.8V W 1492 1073 841 699 529 395 321
    A 133.3 95.5 74.5 61.5 46.1 33.9 27.1
    10.5V W 1713 1195 931 768 575 420 335
    A 153.1 106.2 82.4 69.8 51.4 36.1 28.3
    10.2V W 1781 1239 962 792 590 428 339
    A 159.1 110.2 85.2 69.8 51.4 36.7 28.6
    9.6V W 1848 1284 997 820 610 442 349
    A 165.1 114.2 88.2 72.2 53.2 37.9 29.5
   
    蓄电池交货时,经完全充电[电压14.4V/只(MAX. 0.25C20)充电16Hr]后,1天内测试应达上述放电容量100%以上。
    The battery at time of delivery capacity shall be read more than 100% within 1 days after being changed at 14.4V(MAX. 0.25C20)during 16Hr.
   
    开路电压 Open circuit voltage:蓄电池交货时,开路电压应达12.6V以上,但必须在交货7天以内测试。 The battery at time of delivery shall read 12.6V(OV)or more, provided it is measured within 7 days after delivery.
   
    内部电阻 Internal resistance:
    完全充电后以AC桥式(1KHz)测试,必须低于12mΩ以下。 Give a full charge to the battery, and measure with AC bridge (1KHz), when readings shall be less than 12mΩ.
   
    最大连续放电电流 Maximum continuous discharge current: 10C20(A)放电5秒,电池不得有异常现象。 No deterioration shall be found with 10C20(A)discharge for 5 seconds.
   
    充电 Charging:
    充电方式 Method 电压设定 Given Voltage 充电最大电流 Maximum charging Current 说明 Special condition(S)
    浮动充电方式 Float Charging 13.65V±0.15V 0.25C20(A) 当环境温度上升时,充电电压必须降低避免造成过充电。因此建议以 -3mV/℃/cell(25℃基准值)做温度校正补偿。 As the average ambient temperature rises, charging voltage should be reduced to prevent overcharge. Accordingly, the recommended compensation factor is -3mV/℃/cell at 25℃ of standard centre point.
    循环充电方式 Cyclic Charging 14.4V~15.0V 0.25C20(A) 当环境温度上升时,充电电压必须降低避免造成过充电。因此建议以 -4mV/℃/cell(25℃基准值)做温度校正补偿。 As the average ambient temperature rises, charging voltage should be reduced to prevent overcharge. Accordingly, the recommended compensation factor is -4mV/℃/cell at 25℃ of standard centre point.
   
    使用温度范围 Permissible temperature range:
    状 态 Conditions 温度范围 Temperature range
    放充放 电 Discharging 电 Charging 置 Standing -15℃~50℃0℃~40℃-15℃~40℃
   
    放置期限 Storage period without use:
    温度状况 Storage temperature 容许放置期限 Max. storage period
    25℃以下 (25℃or less) 6 个月 months
    30℃以下 (30℃or less) 4 个月 months
    35℃以下 (35℃or less) 3 个月 months
    40℃以下 (40℃or less) 2 个月 months
   
    期待浮充寿命 Expected float use life:测试条件Test condition:以13.65±0.15V定电压持续充电,每3个月后以0.25C20(A)放电至10.2V终止电压。 3年内电池容量必须维持在2Hr以上。 Charge at 13.65±0.15V continuously and discharge at 0.25C20(A)to FV 10.2V every 3 months.
    Battery shall last minimum 3 years until the capacity falls to 2Hr.
   
    机械强度 Mechanical strength:
   
    耐振动性能 Anti-vibration performance:振幅 : 4 mm 频率 : 16.7 Hz 任意方向连续60分钟振动后,目视检查电池不得有漏液、异常现象,测定电压应达12V以上。 Vibrate the battery in any directions for 60 consecutive minutes with 4 mm amplitude
    and 16.7 Hz per minute. Read the voltage and make visual inspection. Battery shall show no extreme damage or no electrolyte leakage and should read nominal 12V or more.
   
    耐冲击性 Anti-impact performance:在厚约10mm以上之硬木板上测试,由20cm高处落下(方向任意,但端子部除外)一次后,目视检查不得漏液、异常现象,测定电压应达12V以上。 Drop it from a 20cm height onto a 10mm thick solid wooden block in any directions
    except terminal portions. Read the voltage and make visual inspection. Battery shall show no extreme damage or no electrolyte leakage and should read nominal 12V or more.
   
 
安装条件
 
 
    蓄电池的收纳容器不得为密封构造,收纳容器请务必设置通往外部的通气孔。若在金属制的收纳容器内使用蓄电池,则为了避免蓄电池因电槽(外壳)破裂而产生漏液,导致收纳容器或固定架与蓄电池之间形成漏电回路,请在两者之间配置具耐热、耐酸性且不会因固定时的应力而造成破损的绝缘片或绝缘匣,或者将蓄电池装入绝缘袋中。上述绝缘物请使用不会在表面附着油脂类、或由绝缘物内部渗出有机物之绝缘物。蓄电池请勿与含有可塑剂的乙烯绝缘带、绝缘片或溶剂、油脂等接触。
    Storage container for rechargeable battery must not be of sealed and air tight construction; the container must be equipped with ventilation holes leading to the outside. The following applies to using a rechargeable battery inside a metallic storage box: to prevent the rechargeable battery from leaking fluid due to a breakage in the electrolytic cell, thus forming a leak circuit between the battery and the storage box (or fixed frame), install between these two items a heat- and acid- resistant insulating sheet (or tray) that will not be damaged by periodic stress. Alternatively, place the rechargeable battery inside an insulating bag. For the above described insulation material, do not use any material that can be stained with grease, or that can have organic substance oozing out of itself. Do not allow the rechargeable batter to come into contact with vinyl tape containing plasticizer, insulation sheet, solvent, or grease.
   
   
    使用不同种类、容量、批号电池串 联,或并联组数超过三组以上,或循环使用,请事先与本公司联络。
    Use different kinds, capacity, lot number of battery to series connection, or parallel connection more than three groups, or cycle use, please get in touch with our company beforehand.
   


产品留言

台湾汤浅NP40-12B电池相关产品

以上信息由企业自行提供,该企业负责信息内容的真实性、准确性和合法性。仪表展览网对此不承担任何保证责任。
Copyright@ 2003-2010  昱跃国际贸易(上海)有限公司版权所有      苏ICP备07040700号   网站管理入口